Speedmasters 1-147-001 LowRise Intake Manifold Satin For Chevy SBC 350 1957-1995

Description

Fitment and Product Information
Chevy SBC 350 LowRise 1957-95 (Non Egr) Intake Manifold Satin
Brandname:
Speedmasters
Part Number:
1-147-001
Product Details:
The Speedmaster LowRise Manifolds are our lowest profile manifold and is also the only one that is street legal on pollution controlled vehicles. It is set up to accept a spread bore carb but comes with an adapter plate that permits the use of square bore carbs. To remain street legal with a square bore carb, you must use one that is also approved as street legal for your application.
This Speedmaster LowRise manifold is a direct replacement for the stock manifold on 1957-95 Small Block Chevy non-EGR engines.
Includes special adapter bushings to fit 1987-95 engines. Use the stock Quadra-Jet carb or 500-650 cfm vacuum secondary carburetor. Kit includes adapter plate to permit use of certain square bore style carburetors. Manifolds are cast from steel molds, not from sand molds. Permanent molds provide a tighter grain casting thereby reducing the occurrence of porosity which can mar the polished finish. Additionally, each Manifold is 100% pressure tested for leaks to eliminate installation problems. This is our most popular manifold and is showing up on many performance street machines and street rods.
Specs
Part Type:
Intake Manifolds, Carbureted
Product Line:
LowRise
Engine Block Style:
Stock/Original Manufacturer standard deck
Carburetor Quantity:
One
Intake Style:
Dual plane
Basic Operating RPM Range:
Idle-5,500
Intake Manifold Height:
4.050 in.
Intake Material:
Aluminum
Intake Finish:
Natural
EGR:
No
Quantity:
Sold individually.
Notes:
Includes bushings for 1987-95 iron heads.
Calculator:
CFM Calculator
WARNING
: This product can expose you to chemicals including Styrene, which is known to the State of California to cause cancer. For more information go to
www.P65Warnings.ca.gov